Speaker System Hookups - Sony STR-DE335 Mode D'emploi

DVD player/AC-3 decoder
What cables will I need?
• Audio cable (not supplied) (1 for each 5.1 CH/DVD
FRONT and REAR jacks)
White (L)
Red (R)
• Monaural audio cable (not supplied) (1 for each 5.1
CH/DVD CENTER and WOOFER jacks)
Black
• Video cable (not supplied) (1 for the 5.1 CH/DVD
VIDEO IN jack)
Yellow
You can play decoded Dolby Digital AC-3 soundtracks
through the speakers connected to the amplifier.
If you have a Dolby Digital AC-3 decoder you can
amplify a decoded Dolby Digital AC-3 soundtrack with
the following connections.
Receiver
5.1 CH/DVD
FRONT REAR CENTER VIDEO
L
R
WOOFER
Where do I go next?
Go on to the next section to connect the speakers.
White (L)
Red (R)
Black
Yellow
Dolby Digital AC-3
decoder, etc.
PRE OUT
CENTER REAR FRONT
WOOFER
VIDEO

Speaker System Hookups

Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response. For specific locations of the
terminals, see the illustration below.
SPEAKERS
SPEAKERS REAR
SPEAKERS
WOOFER
CENTER
For optimum surround sound effect, place your
speakers as shown below.
45°
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Getting Started
FRONT A
SPEAKERS
FRONT B
Rear speaker
60 - 90 cm
(+)
(–)
(continued)
7 US