Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Hookups
The arrow ç indicates signal flow.
CD player
Receiver
L
R
IN
CD
Tape deck
Receiver
L
R
REC OUT
IN
TAPE
DAT/MD
Receiver
L
R
REC OUT
IN
DAT/MD
Turntable
Receiver
L
R
IN
PHONO
• If your turntable has an earth lead
To prevent hum, connect the earth lead to the y SIGNAL
GND terminal on the receiver.
CONTROL A1 Hookups
• If you have a CONTROL A1 compatible Sony CD player
or tape deck
Use a CONTROL A1 cord (not supplied) to connect the
CTRL A1 jack on the CD player or tape deck to the S-LINK
CTRL A1 jack on the receiver. Refer the separate manual
"CONTROL-A1 Control System" and the Operating
Instructions supplied with your CD player or tape deck
for details.
• If you have a Sony CD changer with a COMMAND
MODE selector
If the CD changer's COMMAND MODE selector can be
switched between CD 1, CD 2, and CD 3, be sure to set the
command mode to "CD 1" and connect the changer to the
CD terminals on the receiver.
However, if you have a Sony CD changer with VIDEO
OUT terminals, set the command mode to "CD 2" or "CD
3" and connect the changer to a set of the receiver's video
component terminals (VIDEO 1, VIDEO 2, or LD).
All manuals and user guides at all-guides.com
CD player
OUTPUT
LINE
L
R
Tape deck
OUTPUT
INPUT
LINE
LINE
L
R
DAT/MD
OUTPUT
INPUT
LINE
LINE
L
R
Turntable
OUTPUT
LINE
L
R
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response.
For specific locations of the terminals, see the
illustration below.
FRONT SPEAKERS
WOOFER
REAR
SPEAKERS
For optimum surround sound effect, place your
speakers as shown below.
45°
Front speaker
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 15 mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
Front speakers
Front speaker
Receiver
(R)
FRONT SPEAKERS
R
L
} ]
Getting Started
IMPEDANCE
SELECTOR
CENTER
SPEAKER
Rear speaker
60 - 90 cm
(+)
(–)
Front speaker
(L)
} ]
(continued)
11
EN
Publicité
Table des Matières
