Speaker System Hookup - Sony STR-LSA1 Mode D'emploi

Speaker System Hookup

Required cables
Speaker cables (not supplied)
One for each speaker
(+)
(–)
ANALOG IN
R L
Terminals for connecting the speakers
Connect the
Speakers (4 to 16 ohms)
Notes on speaker system hookup
• Twist the stripped ends of the speaker cables about 10
mm. Be sure to match the speaker cable to the
appropriate terminal on the components: + to + and –
to –. If the cables are reversed, the sound will be
distorted and will lack bass.
• If you use speakers with low maximum input rating,
adjust the volume carefully to avoid excessive output
on the speakers.
To avoid short-circuiting the speaker
cables
A short-circuiting in the speaker cables will mute the
speakers, and may even damage the receiver. To prevent
this, make sure to take the following precautions when
connecting the speakers.
(+)
(–)
i.LINK S200
v v
To the
SPEAKERS terminals
Right speaker (R)
e
E
+
R
75Ω
U
COAXIAL
FM AM
–
ANTENNA
Make sure the stripped ends of each speaker
cable do not touch another speaker terminal or
the stripped end of another speaker cable.
Examples of poor conditions of the speaker cable
Stripped speaker cable is touching another speaker
terminal.
Stripped cables are touching each other due to excessive
removal of insulation.
Left speaker (L)
e
E
+
L
IMPEDANCE
– USE 4-16Ω
SPEAKERS
7 GB