Festool CLEANTEX CTL 48 E LE EC/B22 Notice D'utilisation D'origine page 16

CTM 48 E LE EC/B22, CTL 48 E LE EC/B22
GB
7.2 Connecting electric power tools
WARNING
Risk of injury
Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
Make sure that the power tool is switched
off before connecting or disconnecting.
Connect the electric power tool to the ap-
pliance socket [1-11].
7.3 Connecting pneumatic tools
WARNING
Risk of injury
Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.
With the compressed air module [1-3], the
automatic switch-on function for the mobile
dust extractor also works in conjunction with
air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool air tools to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to func-
tion correctly.
7.4 Connecting the energy box
The connection for the energy box (EAA)
4] allows you to connect the mobile dust ex-
tractor with the EAA in order to couple the
automatic switch-on unit on the mobile dust
extractor with the equivalent unit on the
EAA.
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s.
Possible causes
Value set on the suction power adjuster
10] is too low.
Rotary knob [1-8] not set to the correct
hose diameter.
Suction hose blocked or kinked.
16
7.5 Adjusting the suction power
You can use the suction power adjuster
10] to adapt the machine suction power to
different applications.
7.6 Applying the brake
Folding out the black brake lever
vents the mobile dust extractor from rolling.
To achieve this, lift the front end of the mo-
bile dust extractor slightly and push the
black brake lever downwards until it latches
into place. Push the green lever
to release.
7.7 Temperature cut-out
A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
Switch off the mobile dust extractor and
allow to cool for approx. 5 minutes.
Change the cooling air filter if necessary
(see chapter 9.2).
If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.8 Changing the filter bag (SC-FIS-
CT 48)
Removing the filter bag
Open the locking clips
the top section of the machine[2-1].
Remove the filter bag.
Dispose of the used filter bag in accor-
dance with statutory regulations.
Inserting the filter bag
Insert a new filter bag (SC-FIS-CT 48) in
the inlet port of the dust container and in-
terlock it. Important: be aware that the
[1-
locking engages.
Make sure that the filter bag is not
pinched between the top and bottom sec-
tions.
Replace the top section
the locking clips [2-2].
Solution
[1- Set the suction power adjuster to a higher
value (see Chapter 7.5).
Set the knob to the correct hose diameter (see
Chapter 7.1).
Remove blockage or kink.
[1-
[1-15] pre-
[1-14] again
[4]
[2-2] and remove
[5]
[2-1] and close