Daikin FXFQ07TVJU Manuel D'installation page 16

• Use a 90° elbow type of conduit with dimensions Fig. 23-1 to prevent it from hitting the swing motor hous-
ing of decoration panel.
• Do not dispose the screw which assembles casing and resin together. The screw will be used to install
conduit mounting plate. Make sure to install the conduit mounting plate first before wiring.
Power supply and
ground wire
Insulation
tube (16)
[ Power supply wiring, Ground wiring ]
Sheathed
part
Ground
wiring
R10
or more
13
<1-3/8 (35)
≥
3/8 (10)
Conduit mounting
Sheathed part of
plate (17)
remote controller wiring,
transmission wiring
Printed Circuit
Board
Clamp (4)
L
1
After the
L
2
wirings are
clamped, cut
off the extra
part.
Ground terminal
Conduit mounting plate (17)
Screw
Fig. 23-1
[Remote controller wiring, Transmission wiring]
Prohibited
• Do not connect the power supply wiring (high voltage).
Remote
controller wiring
Approx.
Forced
1/4 in. (7 mm)
off
Strand the
wirings after
sheath is
2-3/4 to 3-1/2 in.
peeled off.
(70 – 90 mm)
(Sheath peeling
off allowance.)
Terminal block for
power supply wiring/
grounding wiring (3P)
Wiring diagram label
(on backside of control box lid)
Fig. 23-2
Transmission
wiring
P1 P2 F1 F2 T1 T2
3/8 to 5/8 in.
(10 – 15 mm)
R10
or more
Clamp (4)
After the wirings are clamped,
cut off the extra part.
Transmission
wiring
Wiring
penetrating
hole (low
Remote
voltage)
controller wiring
Terminal block for
remote controller wiring/
transmission wiring (X1M)
Control box lid
3P161684-7N English