Uline H-1679 Mode D'emploi page 8

III. HANDLE INSTALLATION
1. Remove handle from protective
2. Loosen set screw (140) on crank link
Figure 7
(139H)
3. Remove 3 hex screws (H109) and 3
4. Feed Wire, Chain and Pin (H107) on
Figure 8
PAGE 8 OF 62
ASSEMBLY INSTRUCTIONS CONTINUED
wrapping.
(139H). (See Figure 7)
Set Screw
(140)
spring washers (H110) from bottom of
handle.
bottom of handle through center of
base (103) and axle (109). (See Figure 8)
H107
103
5. Attach handle to base (103) using 3
hex screws (H109) and 3 spring washers
(H110) and tighten with Hex Wrench
provided. (See Figure 9)
Figure 9
6. While raising crank link (139H), slide pin
of rod and chain (H107) into crank link
groove. (See Figure 10)
Figure 10
REFERENCE PARTS DIAGRAMS
Axle
(109)
Hex
Screw
(H109)
Spring
Washer
(H110)
(103)
Crank
Link
(139H)
H107
PAGES 16-19
0522 IH-1679