Uline H-1394 Mode D'emploi

H-1394, H-1395, H-1396
H-1397, H-3859, H-3860
GRAVITY CONVEYOR
Conveyor Bed Width
Load Capacity Per Linear Foot (305mm)
Skate Wheels Per Axle (1⁄" Steel or Black Polyolefin)
Skate Wheels Per Axle (1⁄" Steel or Black Polyolefin)
Skate Wheels Per Axle (1⁄" Steel or Black Polyolefin)
Casters (Brake and non-brake swivel with rubber wheel)
Adjustable Conveyor Height
Expansion to Compaction Ratio
Expansion to Compaction Ratio
Expansion to Compaction Ratio
1. Unpack and inspect your expandable conveyor.
2. Unlock the casters and roll the conveyor into the
working area. Lock the casters.
3. If your conveyor arrived in two or more sections that
need reconnecting (See Figure 1) into one system,
see connecting instructions below:
a. Tools required for assembly include two
wrenches in each of these sizes: 7/16", 1/2", 9/16".
b. Remove cap nut from axle of roller angle
assembly "B" (both sides).
c. Remove bolt, nylatron washer, and jam nut from
lower side bar section "A".
d. Roll section "A" and section "B" together making
sure outside side bars are on the outside and
inside side bars are on the inside (both sides).
e. Slide axle of roller angle assembly "B" back
and forth to connect section "A" top side bar to
section "B" side bar (both sides). Replace cap
nut on axle of roller angle assembly "B" and
hand tighten only.
PAGE 1 OF 21
1-800-295-5510
uline.com
SPECIFICATIONS
INSTALLATION AND OPERATING INSTRUCTIONS
Pour le français, consulter les pages 15-21.
In (mm)
Lbs (kg)
18" (457mm)
24" (610mm)
30" (762mm)
In (mm)
In (mm) 28⁄ to 41⁄" (724 to 1,054)
5" (127mm) Axle Center
4" (102mm) Axle Center
3" (76mm) Axle Center
f. Connect section "A" bottom side bar to section "B"
bottom side bar using hardware removed in step
2 (both sides).
NOTE: Plastic nylatron washer must be between
side bars as illustrated in Figure 1.
g. Tighten capnut on top side bar and jam nut on
bottom side bar (both sides).
Figure 1
Roller
Assembly B
Washer
Roller
Assembly A
Section A
Inside Scissor
Outside Scissor
Locknut
Para Español, vea páginas 8-14.
18, 24, 30 (457, 610, 762)
250 (113.4)
7
9
10
5 x 1⁄" (127 x 32)
4.0:1
3.2:1
2.4:1
Section B
Cap Nut
Washer
0521 IH-1394
Axle
Bolt