Assembly - Uline H-1679 Mode D'emploi

I. CAREFULLY UNPACK ALL ITEMS
1. Remove control panel from packing
Figure 1
II. ATTACH CONTROL PANEL
1. Feed excess cable into the control
Figure 2
2. Remove the two screws (one on each
Figure 3
PAGE 7 OF 62
foam. (See Figure 1)
panel head. Align three holes in control
panel with three holes on pallet truck
base. (See Figure 2)
side) to release the front panel. Carefully
open the front panel. (See Figure 3)
ASSEMBLY INSTRUCTIONS
3. Align mounting holes on pallet truck with
mounting holes on control panel. (See
Figure 4)
Figure 4
4. Insert and tighten 3 hex screws (H109)
with spring washers (H110) through
base of control panel with hex wrench
provided. (See Figure 5)
Figure 5
Hex Screw Hex Screw
(H109) (H109)
Washer
(H110)
5. Close front panel and secure with
2 screws. (See Figure 6)
Figure 6
0522 IH-1679