Uline H-1679 Mode D'emploi page 10

ENSURE FORKS RAISE/LOWER
PROPERLY
Control Lever (H106) is located on pallet
truck handle (H101) and can be set to 3
positions: LOWER, NEUTRAL and ASCENT.
1. Tighten set screw (140) on crank link
2. If forks elevate while pumping with
3. If forks descend while pumping with
4. If forks do not descend when Control
5. If forks do not elevate while pumping
LOWER
CHARGING THE BATTERY
1. Connect AC adapter into the plug on the
2. Charging time is approximately 15 hours.
BATTERY STATUS (L.E.D. INDICATOR)
•
•
PAGE 10 OF 62
(139H) until LOWER position on Control
Lever functions properly. (See Handle
Installation Step 2).
Control Lever in NEUTRAL position, turn
set screw clockwise until pumping the
handle no longer elevates forks and
NEUTRAL position functions properly.
Control Lever in NEUTRAL position, turn
set screw counter-clockwise until forks
LOWER
no longer descend.
Lever is in LOWER position, turn set
screw clockwise until forks lower while in
LOWER position.
with Control Lever in ASCENT position,
turn set screw counter clockwise until
the forks elevate while pumping in the
ASCENT position. Be sure to re-check
NEUTRAL
NEUTRAL and LOWER positions to ensure
proper functioning.
side of the control panel. Plug cord into
110/120V AC outlet.
Green - Battery is fully charged.
Red - Battery is charging.
BASIC OPERATIONS
LOWER
NEUTRAL
ASCENT
NEUTRAL
ASCENT
0522 IH-1679