Uline H-959 Données Techniques

H-959
POLYPROPYLENE
STRAPPING MACHINE
TECHNICAL DATA
Strapping Speed: 2.5 Seconds/Strap
Dimensions (L x W x H): 35½ x 23 x 30½"
Net Weight: 220 lbs.
Max. Tension: 100 lbs.
Strap Width: 1/4" – 5/8"
Core Capacity (Core Dia. x Width): 8 x 8", 9 x 8" or 11 x 8"
Safety Switch: Stops machine when top is lifted.
Power: 110 VAC, 50/60 Hz, Single phase.
Open lid and remove contents from tray. Install package guide on lid.
L O A D R E L E
Right Side
1. Remove plastic reel from machine. It comes preset
for 9" core. Remove outer ring adapter for 8" core.
For 11" strapping core, the H-959-TC075 adapter can
be purchased. (See Figure 1)
2. Load Strapping onto reel. DO NOT REMOVE BANDING
UNTIL LOADED. Make sure strap is going in correct
direction indicated by red arrow. (See Figure 1)
PAGE 1 OF 9
1-800-295-5510
uline.com
MACHINE SETUP
R O
Remove adapter
before installing
reel.
Figure 1 Figure 2
3. Pull slide roller bar down and thread strapping over
Pour le français, consulter les pages 7-9.
POW ER
LEN GTH
RES ET
2 3
ON FEE D
4
OFF 5
0 MAX
M
U E T S R T A P P N I G
Slide Roller
BAND GUIDE
(1) and under (2). Thread strap through guide (Ref
10) until it reaches top of machine. (See Figure 2)
Para Español, vea páginas 4-6.
1
2
Roller
0221 IH-959