Control Of The Convector - Sonnenkonig SLIM M 1000 Guide D'utilisation

5 Control of the convector

The models SLIM 1000 M, SLIM 1500 M and SLIM 2000 M are equipped with a mechanical
thermostat.
SLIM M 1000 / SLIM M 1500 / SLIM M 2000 Control panel
1. Heating" indicator light
It is illuminated when the unit's heating is on.
2. Thermostat handle
It is used to set the desired room temperature.
3. Two-button switch, with display
It is used to select the following heating power modes: I mode (low power), II mode (medium
power), III mode (high power).
Operation of slim series convector
1. Switch on the convector
Connect the convector to electric mains by plugging the power cord into an eletric outlet.
2. Select the heating power
2.1 Press button "1" to select low heating power, at that the indicator light of button "1" will be
illuminated.
2.2 Press button "2" to select the medium heating power, at that the indicator light of button
"2" will be illuminated.
2.3 Press button "1" and "2" to select the high heating power, at that indicator lights of both
buttons will be illuminated.
3. Set temperature
3.1 Temperature can be set within the range +5 to +30° C.
3.2 Turn the thermostat handle clockwise to the stop to positon "max", at that is room tempe-
rature is below the set one, then the "heating" indicator light must be illuminated. When
the room temperature reaches the desired level, turn the thermostat handle counter-
clockwise until the unit is switched off, the "heating" indicator light will go out. Now the
thermostat will maintain the set temperature, switching on and off the convector from
time to time.
53
EN
(Fig. 8)