Gasleak Testing; Control - Sonnenkonig 30310088 Mode D'emploi

05 - GASLEAK TESTING

The gas connections are tested for tightness in the factory before delivery. A complete leak test
must be carried out at the installation site after installation.
During the test, no heat and fire sources can be present in the vicinity of the device!
1. Mix a soap solution of one part liquid cleaner and one part water. The soap solution can be
applied with a spray bottle, brush or cloth. In case of a leak, soap bubbles will form.
2. The heater must be checked with a full gas bottle.
3. Make sure that the regulator is set to OFF.
4. Turn the gas supply completely on.

06 - CONTROL

Pilot
Gas supply only when
controller is pressed.
Low
Minimal gas supply.
Weak flame in the
burner.
Igniter
Piezo-ignition (no bat-
terie). Creates sparks
when fully pressed
Gas supply completely
interrupted. No flame
in the burner
Controller
Turn to regulate the
flame. Press to open
the gas supply (pilot).
High
Maximal gas supply.
Strong flame in the
burner.
Off
EN
51