Remote Control; Inserting Batteries - Sonnenkonig MARS Mode D'emploi

Remote Control

1 Power button: Turn the heater off.
2 Up button: Increase temperature, timer and level.
3 Down button: Decrease temperature, timer and level.
4 Level button: Use to adjust the 2P heat levels(P1-P2). Press the
Level button then use the up and down buttons(buttons 2 and 3)
to increase or decrease the heating level.
5 Timer button: To set the timer from T0-T9, which is the number
of hours it will run. T0 will display and then adjust to the number
of hours you would like to set, using the up and down buttons(2
and 3).
Noted: All sonnenkönig heaters and their remote controls have the same
frequency, so it is possible to control several heaters with just one remote.
PUSH BUTTON: on the right end of heater, it could be manual oper-
ated without remote control.

Inserting Batteries

Insert 2 AAA/ Alkaline type batteries into your remote control
1 Flip the backside of your remote control and pull out battery cover. Insert the batteries in
accordance with the instructions and polarity the batteries.
2 Change the batteries in the same way depicted above.
NOTICE:
1 Replace the old batteries with the same type batteries. Otherwise, your heater may not func-
tion well.
2 Pull out the batteries in case of long terms of disuse to prevent leakage which may impair
your remote control.
3 Do not allow water or liquid to get into the remote control.
Caution:
When the appliance is not operated for a long period of time, cleaning or maintenance is con-
ducted or when the location of the heater is changed, the heater should be turned to OFF and
unplugged from the electrical connection. Periodic inspection and removal of dirt and contami-
nants will ensure that equipment can be operated safely.
5. Troubleshooting
1 Check if the power cord is plugged into an electrical outlet, if not, plug in.
2 Check if electricity to the main fuse is working
3 Check to see it the thermostat knob to the ON position
4 Check the thermostat setting, the heater may be off because it has reached the desired
temperature setting.
45