Perfomance Pararameters - Sonnenkonig SLIM M 1000 Guide D'utilisation

• Do not switch on the convector if its power cord or plug is damaged. To prevent electric shock,
the damaged power cord must be rapaired only in authorized service centers of the manu-
facturer and by skilled specialists.
• Never try to reqair it in your own, This may harm your health and affect the unit's guarantee
maintenance.
EN
• Do not use the convector in open spaces outside.
• It is forbidden to install and use the unit in bathroons, shower rooms or swimming pools, in the
very places, where water jets or drops may contact its surface directly when it is switched on.
• Do not lay the convector's power cord under carpets and do not press it by furniture. Lay the
power cord in such a manner so that it is impossible to trip over it.
• Do not thrust fingers and prevent entering of foreign objects into any ventilation, air intakes or
air outlets, since it may cause electric shock or damage of the convector.
• To prevent a potential fire, do not block air intakes and air outlets. Do not hang dry things on
the convector! Use the convector only on a dry smooth surface.
• The convector contains internal hot and sparkling components. Do not use the convector in
places, where petroleum, paint or any other flammable liquids are used or stored.
• Use this convector only in the manner, set forth in this manual. Any other use, not recommen-
ded by the manufacturer, can result in a fire, electric shock or injuring of people.
• By no means clean the convector when it is connected to the mains. Do not submerge the
convector into water. Never pull the power cord.
• To prevent overheating and fire, as well as damage of internal electric mains, do not change
the length of the power cord and do not connect the unit through an electric extender, if its
paramenters do not comply with the unit's power and if it is used by other power energy
consumers.
• For normal operation of the unit the mains voltage must be suffcient and its technical
paremeters must be in strict compliance with technical parameters indicated on the unit. If
necessary, verify characteristics of your mains at the power energy supplier.
• Install and operate the unit vertically only. It is fobidden to use the unit in a horizontal or
inclined position.
• The unit must be intalled in such a way so that the control panel would be unavailable for
a person, situated directly in a bathroom (in contact with water) or a person taking a shower.
• It is forbidden to intall the unit directly under an outlet or under a laid electric cable when
outgoing heat flows come in contact with it. It may cause their overheating and creat an
emergency.
• The unit is not intended to be used by people (including children) with limited physical,
sensory or intellectual capabilities, having insufficient experience and knowledge, unless they
are supervised or received insructions on how to use the unit from a person, responsible for
their safely. It is necessary to be careful that children do not play with the convector.

2 Perfomance Pararameters

Operation principle
Cold air in the lower pary of a room at the level of feet goes through the convector's heating ele-
ment. Expanding at the moment of heating, heat flow runs upwards through the outlet grill louver
and smoothly spreads along the room. At that the flow's direction, set by louver's inclination, creats
a favorable, accelerated circulation of warm air inside a room, not concentrating it on walls and
windows.
48