Installation - Sonnenkonig SLIM M 1000 Guide D'utilisation

4 Installation

Wall mounting of the convector (Fig. 4,5,6) dimensions are given in mm.
1. Open the factory package and carefully remove the unit out of it.
2. Remove seals out of foamed plastic on sides of the unit and take it out of polyethylene.
3. In accordance with Fig. 2,4 and table 2, determine the place of convector's installation
observing minimun distances from objects and minimun distance from the floor.
4. Make the height, at which the convector is to be mounted, then attach bracket to the wall.
5. Put visible marks in mounting holes.
6. Drill holes of the required diameter on the mounting holes, inset dowels, attatch the mouting
bracket and fasten adjusting screws, thereby securing bracket on the wall (Fig.5).
7. Suspend the convector on the bracket, for which purpose attach the lower part of the unit
to the lower extension of the bracket and insert them into slots, available in the lower part of
the unit's rear panel. Carrying out these actions, it is necessary to hold the unit at the angle
of ~50-60 degrees (Fig.6).
8. Turn the unit in a horizontal plain until upper extensions of the bracket coincide with the
upper slots in the unit's rear panel and slightly press on the unit until you hear clicking of the
upper extensions (Fig.6).
9. To dismount the unit press the leverages of the bracket's upper extensions and disconnect the
unit from it. Then carry on the abovementioned operations in the reverse order.
(Fig. 4)
51
(Fig. 4)
(Fig. 5)
EN