Appendix 2; Copyright - Focusrite ISA428 MkII Mode D'emploi

Table des Matières

Les langues disponibles

Appendix 2

Digital Card Jumper Positions - Disabling AES Outputs 5-8

Four jumpers on the digital card can be made to disable channels 5-8 on the AES Output. This is so that a standard

25-pin to 25-pin Pro Tools™ cable can be used to record channels 1-4 at 192kHz. (Half of the connections on the

Digidesign Digital connector are used for receiving and the other half for transmitting.) For more information, consult the

relevant section of the Pro Tools™ User Guide.

As shown on the card, with the jumpers in the lower position (on the bottom two pins), outputs 5-8 are enabled.

Removing the jumpers and placing them in the upper position (on the top two pins) disables outputs 5-8, as shown:

AES Outputs 5-8 disabled (default)

AES Outputs 5-8 enabled

Focusrite and ISA are registered trade marks of Focusrite Audio Engineering Limited.

Table des Matières

Table des Matières