Gima Oxy-100 Instructions De Fonctionnement Et D'entretien page 36

During the period of validity of the warranty, GIMA will repair and/or replace
free of charge all the defected parts due to production reasons. Labor costs
and personnel traveling expenses and packaging not included. All components
subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not
extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized
personnel or with non-original spare parts, defects caused by negligence or
incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or
software due to outside agents such as: voltage changes, electro-magnetic
fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial
code (if available) has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was
purchased from. Products sent to GIMA will be rejected.
9 Troubleshooting
Trouble
Unstable SpO
2
Pulse Rate display
D e v i c e w i l l n o t
switch on
No Display
ENGLISH
Possible Reason
and
1. The finger is not placed
far enough inside.
2. The finger is shaking or
the patient is moving.
1 . T h e b a t t e r i e s a r e
drained or almost drained.
2. The batteries are not
inserted properly.
3 . T h e
malfunctioning.
1. The device will power
off automatically when
there is no signal and no
operation for 1 minute.
2. The batteries are almost
drained.
Solution
1 . P l a c e t h e f i n g e r
correctly inside and try
again.
2 . R e d u c e p a t i e n t
movement.
1. Change batteries.
2. Reinstall batteries.
3. Please contact the
local service center.
d e v i c e i s
1. Normal.
2. Change batteries.
36