Gima Oxy-100 Instructions De Fonctionnement Et D'entretien page 25

ENGLISH
25
Instructions of Operation
1. The finger should be put in properly and correctly.
2. Do not shake the finger and keep at ease during measurement.
3. Do not put wet finger directly into sensor.
4. Avoid placing the sensor on the same limb which is wrapped with a cuff for
blood pressure measurement or during venous infusion.
5. Do not let anything block the emitting light from the sensor.
6. Vigorous exercise and electrosurgical device interference may affect the
measuring accuracy.
7. Using enamel or other makeup on the nail may affect the measuring
accuracy.
8. If the first reading appears with poor waveform (irregular or not smooth),
then the reading is unlikely true, the more stable value is expected by waiting
for a while, or a re-inserting finger is needed when necessary.
4 Operation
4.1 Power on/off the Oximeter
- When the device is off, press " " power/back key for 2 seconds to power
up the Oximeter, then it will enter into measurement display screen.
- If the Oximeter is working, longtime press " " power/back key to power it off.
- During measurement, if the "probe off" is detected for longer than one minute,
then the device will power off automatically.
- If not in the measurement state and there is no any key operation for 1 minute,
the device will power off automatically as well.
4.2 Default Display Screen
Press " " power key for 2 seconds to start up the Oximeter, then insert the
finger into the rubber cushions of the probe, the screen will display the default
screen, as shown in Figure 4-1.