Gima Oxy-100 Instructions De Fonctionnement Et D'entretien page 29

ENGLISH
29
- Time: Time setting
- Recording: Time interval for recording data (SpO & PR), there are five
2
options: "1s, 2s, 4s, 8s" and "OFF".
1) "1s": the least length of data record is set to 30 seconds, and the maximal
length for one record is limited to 1 hour. The total storage time is up to 48 hours.
2) "2s": the least length of data record is set to 60 seconds, and the maximal
length for one record is limited to 2 hours. The total storage time is up to 96
hours.
3) "4s": the least length of data record is set to 120 seconds, and the maximal
length for one record is limited to 4 hours. The total storage time is up to 192
hours.
4) "8s": the least length of data record is set to 240 seconds, and the maximal
length for one record is limited to 8 hours. The total storage time is up to 384
hours.
5) When the option is set to "OFF", the device will not store the measuring data.
- Power saving: power saving setting; two options: "on" and "off". The factory
default setting is "on". If the power saving mode is on during measurement,
and there is no key operation for 2 minutes, the screen display will be dim
for power saving. The display brightness will resume to normal condition by
pressing any key.
4.4.2 Upload Data
On the menu screen, select "UPLOAD DATA" and then press " " key for
entering into connecting status (as shown in Figure 4-5). When you transmit
data (SpO and PR values) to your computer, please let the oximeter stay in
2
connecting status. Do the following operation by the instruction in "Oximeter
Data Manager User Manual". The data uploading will be activated.
Figure 4-5 Connecting Status Screen