Filter Slide - SCHOTT KL 1500 HAL Mode D'emploi

KL 1500 HAL / KL 1500 H - Operating instructions

2.7 Filter slide

The KL 1500 HAL has a filter slide (7) which can be fitted with an insert filter (available as
accessory).
When operating the light source, the filter slide must always be engaged in one of the end positions
or in the rest position.
!
Safety information:
ATTENTION!
Operating the light source with the filter slide in an intermediate position can cause damage to the
slide.
Fitting the filter slide
!
Safety information:
ATTENTION!
Please ensure the filter slide (7) has cooled down before fitting the insert filter. A warning sign has
been attached to remind you of this necessity.
Completely pull out the filter slide (7) from the light source so that the label is legible (left). Insert the
filter with 28 mm diameter using lint-free gloves from top right behind the two retaining lugs and fix it
with slight pressure (center). The filter is then lying flat inside the holder (right).
To remove easily bend the bracket (left) to the left and remove the filter with gloves.
If you wish to operate the light source for a short time without a filter then only pull the slide out to
the first rest position. When in this position, the filter is still in the light source, but no longer in the
light path.
10/15