Enter/Change Password - Lenze EEPM1RA Instructions De Mise En Service

4.16 Enter/change password
When a password has been set, only the main menus can be accessed until the correct password has been entered.
• MASTER –> EPM
• DISPLAY CONTRAST
• MISCELLANEOUS (without the submenu PASSWORD).
Press
1.
MENU
2.
ENTER
3.
4.
ENTER
5.
6.
ENTER
7.
MENU
The display shows...
MISCELLANEOUS
S/W VERSION X.XX
PASSWORD: 0000
PASSWORD: 0000
PASSWORD: XXXX
PASSWORD: XXXX
MISCELLANEOUS
ENGLISH
Operation
Explanation
Press the key until the menu appears in the display.
Takes you to the submenu. The cursor is blinking in
the display on the left.
Displays the set password for the access protection
(Factory setting: 0000).
When the password is set to 0000, the access
protection is deactivated.
The cursor is blinking in the display on the right.
Enter a password. Any value between 0000 and
9999.
Use the buttons to select a value. To scroll
quickly to a value, keep the key pressed. The scroll
rate increases as you hold the button.
The cursor is blinking in the display on the left.
The new password has been stored.
Returns to the main menu.
19