Victron energy Phoenix MultiPlus 12/3000/120 Manuel page 35

5.5.2 Step 2: Other settings
The remaining settings are not relevant (na) for slaves.
Some of the remaining settings are not relevant for followers (L2, L3). These settings
are imposed on the whole system by the leader L1. If a setting is irrelevant for L2, L3
devices, this is mentioned explicitly.
ds8-ds7: Setting charging voltages (not relevant for L2, L3)
Absorption
ds8-ds7
voltage
14.1
off off 28.2
56.4
14.4
off on 28.8
57.6
14.7
on off 29.4
58.8
15.0
on on 30.0
60.0
ds6: absorption time 8 or 4 hours (na for L2, L3)
ds5: adaptive charging characteristic (na for L2, L3)
(fixed absorption time)
ds4: dynamic current limiter
ds3: UPS function
ds2: converter voltage
ds1: converter frequency (na for L2, L3)
(the wide input frequency range (45-55Hz) is 'on' by default)
Float Storage
oltage voltage
13.8 13.2
27.6 26.4
55.2 52.8
13.8 13.2
27.6 26.4
55.2 52.8
13.8 13.2
27.6 26.4
55.2 52.8
13.8 13.2
27.6 26.4
55.2 52.8
Suitable for
Gel Victron Long Life (OPzV)
Gel Exide A600 (OPzV)
Gel MK battery
Gel Victron Deep Discharge
Gel Exide A200
AGM Victron Deep Discharge
Stationary tubular plate (OPzS)
AGM Victron Deep Discharge
Tubular plate traction batteries in
semi-float mode
AGM spiral cell
Tubular plate traction batteries in
cyclic mode
on = 8 hours off = 4 hours
on = active off = inactive
on = active off = inactive
on = active off = inactive
on = 230V off = 240V
on = 50Hz off = 60Hz
31