CEDARLANE Bellini Intelli: Maitre de la Cuisine Mode D'emploi page 6

Get to Know the Control
Panel
Power Switch
Power Switch
Press the power switch to on position before
use.
Power Indicator
Light
LCD Screen
Power Indicator Light
When the Intelli Kitchen Master is connected to
the power supply, press the power switch to the
on position (located on the back of the unit).
A red Power Indicator Light situated in the upper
part of the control panel will flash to indicate the
machine is ready to operate. All the functions
that appear on the LCD screen, such as time,
speed and temperature will display "00". The
indicator light will remain this way until the
time, speed or temperature is set. The indicator
light will illuminate in red during the setting mode.
After setting, press the On/Off button (located
on the control panel) to turn the Intelli Kitchen
Master on, the Power Indicator Light's colour will
then illuminate in blue.
Bellini Intelli Kitchen Master
Timer Dial
The Timer Dial is used to program the cooking
and/or the preparation time of the ingredients
for a maximum of 90 minutes with this Timer Dial.
Intelli Kitchen Master can be programmed in
minutes with an interval of 1 second for the first
minute and then in intervals of 30 seconds.
The timing can be increased by turning the
Timer button in clockwise, or decreased time in
anticlockwise. Intelli Kitchen Master counts the
time down and the initial timing of the function
can be changed if needed.
It is necessary to program the operation time.
ON/OFF Button
This button is used to start the Intelli Kitchen
Master after having selected the time, speed
and temperature (although the temperature
function is not always necessary given the
cooking function). When it is ON, the Power
Indicator Light changes from red to blue and the
appliance begins to perform the programmed
task.
To stop the machine, simply press this button
again.
In Standby mode (When the appliance is initially
turned ON via the Power Switch from the back ,
the display screen is lit, but the appliance is not
in operation, e.g Blade speed, timer are not in
motion), press and hold the ON/OFF button on
control panel for approximately 3 seconds to
alternate between C and F temperature units of
measure.
Pulse/Pause button
The PULSE function can only be activated when
appliance is in Standby mode, press this button
to activate PULSE and release to stop PULSE.
In Operation mode (When appliance is in use,
blades are running and timer is counting down)
press this button to pause operation.
The Pulse function is used to mix and chop
ingredients at a very high speed by keeping this
button pressed during the required time usually
of 3 to 4 seconds.
Caution:
When using this function , it is
important to note that the ingredients may splash
and might result in burns if the necessary caution
is not taken. It is therefore recommended to Turn
the Measuring cup to lock position when using
Pulse function. Do not use the Mixing tool with this
function.
6