Wheel Kit Installation - Honda EU65is Manuel De L'utilisateur

Wheel Kit Installation

Do not operate the generator without the wheel kit installed. The
wheel kit provides a clearance between the ground and the generator
air intake.
If the wheel kit is not installed, it may be possible for dirt and debris to
be drawn into the generator air intake, possibly causing generator
damage. Always operate the generator with the wheel kit installed.
1. Install the two wheels on the axle shaft using the 20 mm washers
and 4.0 × 28 mm cotter pins.
2. Install the axle assembly on the generator using four 8
flange bolts and four 8 mm washers (t=2.3 mm).
3. Install the two stands on the under frame using four 8
flange bolts and four 8 mm washers (t=6 mm).
TORQUE: 24 29 N·m (2.4 3.0 kgf·m , 17 22 lbf·ft) −
8 mm WASHER (4)
(t = 6 mm)
8 25 mm ×
FLANGE BOLT (4)
STAND (2)
WHEEL (2)
64
−
8 25 mm FLANGE BOLT (4) ×
×
−
S S H H
8 mm WASHER (4)
(t = 2.3 mm)
20 mm WASHER (2)
AXLE SHAFT
× 25 mm
25 mm
O O R R T T E E R R
4.0 28 mm ×
COTTER PIN (2)