Electrical Connection - Resol VBus/LAN Manuel

Upper part of
the housing
Cover screw
Front view
Molds for the
rubber pads
Base part of
the housing
Back view
3

Electrical connection

ATTENTION!
Opening for
the mounting
ATTENTION!
screw
The VBus
Hanging
and a LAN connection to function. To install the VBus
ble, the housing has to be opened.
Î To open the housing, unscrew the cover screw and
pull off the upper part of the housing.
Î Connect the included VBus
nals with either polarity.
The VBus
wire cable (bell wire). The cross section of the cable must
be at least 0.5 mm
50 m in the case that one module is used.
ESD damage!
Electrostatic discharge can lead to damage
to electronic components!
Î Take care to discharge properly be-
fore touching the inside of the device!
To do so, touch a grounded surface
such as a radiator or tap!
Short circuit!
A short circuit can lead to damage to elec-
tronic components!
Î Finish terminal connection and close
the housing before establishing the
mains connection!
® / LAN interface adapter needs a mains, a VBus
cable to the VBus
®
cable can be extended or replaced with a two-
®
2 and the cable can be extended up to
®
ca-
®
termi-
®
19