Resol VBus/LAN Manuel page 23

4.5 Reset
If the password for the VBus
lost, the device has to be manually reset to the factory
settings. In order to conduct a reset, proceed as follows:
Î Open the housing (see page 18).
Î Press the reset button for 5 s.
During the reset process, the front-LED flashes red.
As soon as the reset is completed, the LED switches to a
permanent red.
Î As soon as the LED switches to a permanent red, re-
lease the reset button!
Î When the reset has been completed, close the hous-
ing (see page 18).
The reset will set the device back to factory settings. All
adjustments made in the Web interface (see page 21) will
be lost and will have to be made again.
/ LAN interface adapter is
®
4.6 Accessing the VBus
over the Internet
Note
The DeviceDiscoveryTool cannot be used for finding
a VBus / LAN interface adapter over the Internet.
®
The following preparations have to be made when a
VBus / LAN interface adapter connected to the Internet
®
via a router is to be accessed over the Internet:
Î Assign a static address to the router.
Î Carry out port routing in the router.
Assigning a static router address
In order to access the router and the VBus
adapter connected over the Internet, a static address has
to be assigned to the router.
There are 2 different ways to assign a static Internet ad-
dress to the router:
• Over a dynamic Domain Name Server (DynDNS)
• Over a static Internet IP address
/LAN interface adapter
®
/ LAN interface
®
23