Electrical Connection - Resol 180 008 80 Manuel

Upper part of
the housing
Cover screw
Front view
Molds for the
rubber pads
Base part of
the housing
Back view
3

Electrical connection

ATTENTION! ESD damage!
Opening for
the mounting
screw
ATTENTION! Short circuit!
Hanging The VBus
and a LAN connection to function. To install the VBus
ble, the housing has to be opened.
Î To open the housing, unscrew the cover screw and
pull off the upper part of the housing.
Î Connect the included VBus
nals with either polarity.
The VBus
wire cable (bell wire). The cross section of the cable must
be at least 0.5 mm
50 m in the case that one module is used.
Electrostatic discharge can lead to damage to
electronic components!
Î Take care to discharge properly before
touching the inside of the device! To do
so, touch a grounded surface such as a
radiator or tap!
A short circuit can lead to damage to elec-
tronic components!
Î Finish terminal connection and close
the housing before establishing the
mains connection!
/ LAN interface adapter needs a mains, a VBus
®
cable to the VBus
®
cable can be extended or replaced with a two-
®
and the cable can be extended up to
2
®
ca-
®
termi-
®
15