Connection; Driver Installation - Resol VBus/USB Manuel D'installation

3. Connection

4. Driver installation

Note
The driver software is not authorised by the
Windows Logo Test. Thus, when installing the dri-
ver under Windows, a security query will appear
asking for permission to continue regardless of
the lacking authorisation. Answer this security
query by clicking "Continue installation".
Distributed by:
Important notice:
We took a lot of care with the texts and drawings of this
manual and to the best of our knowledge and consent. As
faults can never be excluded, please note: Your own calcu-
lations and plans, under consideration of the current stan-
dards and guidelines should only be basis for your projects.
We don´t offer a guarantee for the completeness of the
drawings and texts of this manual - they only represent
some examples. They can only be used at your own risk.
No liability is assumed for incorrect, incomplete or false
information and / or the resulting damages.
Please note:
The design and the specifications are to be changed without notice.
The illustrations may differ from the original product.
To connect the VBus cable, proceed as follows:
®
Î Open the housing as described in chap. 2
Î Connect the included VBus
with either polarity and route the cable as shown in
the figure to the left
Î Close the housing as described in chap. 2
The VBus ® cable can be extended by or replaced with a
two-wire cable (bell wire, cross section at least 0.5 mm
The bus cable can be extended to up to 50 m in the case
of a single connection. Low voltage cables must not run
together in a cable conduit with cables carrying a higher
voltage than 50 V!
Note
To ensure a stable USB connection, the USB
cable should not be extended to more than
5 m in total.
If a cable extension is necessary, a bus cable ex-
tension is preferable to a USB cable extension.
When the VBus /USB interface adapter is connected to a
®
PC for the first time, the driver software has to be installed.
All modern operating systems are equipped with an assistant
software that will guide the user through the installation as
soon as a new device is connected to a USB port.
The driver software required for the VBus
adapter can be found on the CD-ROM included.
RESOL - Elektronische Regelungen GmbH
Heiskampstraße 10
45527 Hattingen / Germany
Tel.: +49 (0) 23 24 / 96 48 - 0
Fax: +49 (0) 23 24 / 96 48 - 755
www.resol.com
info@resol.com
Reprinting / copying
This mounting- and operation manual including all parts is
copyrighted. Another use outside the copyright requires
the approval of RESOL - Elektronische Regelungen GmbH.
This especially applies for copies, translations, microfilms
and the storage into electronic systems.
Editor: RESOL - Elektronische Regelungen GmbH
cable to the terminals
®
).
2
/USB interface
®