Overview; Mounting - Resol VBus/USB Manuel D'installation

VBus /USB interface adapter
®

1. Overview

2. Mounting

ATTENTION! ESD damage!
Electrostatic discharge can lead to da-
mage to electronic components!
Î Take care to discharge properly
before touching the inside of the
device. To do so, touch a grounded
surface such as a radiator or tap!
Upper part of
the housing
Cover screw
Front view
Molds for the
rubber pads
Base part of
the housing
Back view
• for the connection of a PC with a USB port to a
controller with a RESOL VBus
• logging of measured data on the PC by means
of the included RSC software
• evaluation and visualisation of system data pos-
sible with a spreadsheet software
• remote parametrisation of the controller
• no external power supply required
• USB 1.0 and 2.0 compatible
VBus ® /USB interface adapter
The VBus ® /USB interface adapter is the interface between
the controller and a personal computer. With its standard
mini-USB port it enables a fast transmission of system data
for processing, visualising and archiving as well as the para-
metrisation of the controller via the VBus
the RESOL ServiceCenter software is included.
The interface adapter is designed for the connection to
controllers equipped with the RESOL VBus
The unit must only be located in dry interior locations. It
is not suitable for installation in hazardous locations. The
interface adapter is light and small enough to not require
any form of mounting. It can be placed directly on the desk
or on a system component (pay attention to the allowed
ambient temperature!).
Four self-adhesive, skid-proof rubber pads are included with
the adapter. If necessary, these can be affixed to the corre-
sponding molds on the base part of the housing to ensure
a secure placement of the device without wall mounting.
If desired, the interface adapter can be mounted to a wall:
Î Mark the desired hanging position on the wall
Î Drill and prepare the hole with a wall plug and screw
Opening for the
Î Hang the device onto the screw
mounting screw
Î Mark the position for the mounting screw (centres
70 mm)
Î Drill and prepare a hole with a wall plug
Î Hang the device and fasten it by means of the second
screw
Hanging
For wall mounting, opening the housing is not required.
Opening the housing is only required for access to the
terminals.
Î To open the housing, unscrew the cover screw and pull
off the upper part of the housing
Î To close the housing again, relocate the upper part of
the housing and refasten the cover screw
®
. A full version of
®
.
®
7
|