LG GSX960NEAZ Manuel Du Propriétaire page 18

<Push fit Connector Type>
1
Firmly push the water tube connected from
the appliance into the end that has the arrow
pointing outward. Push the tube all the way
in (approx. 10-12 mm).
2
After inserting the tube securely into the
filter, fit the locking clip into position under
the pull up collar.
3
Repeat on the other end of the filter using
the remainder of the water tube.
Connecting to the Water Tap
1
Push the water tube into the hole of the
tap connector supplied in the accessories.
The pipe should be held firmly whilst the
connector is pushed onto the pipe.
Firmly push the water tube connected from
the appliance into the end that has the arrow
pointing outward. Push the tube all the way
in (approx. 10-12 mm).
1
18
2
Ensure that the rubber washer is fitted inside
to the inside of the tap connector before
screwing it onto the tap.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the Water Filter button for
three seconds. That resets the Replacement
Filter icon. The new water filter has been
activated.
3
Place a cup under the water dispenser
to verify that water is flowing throughthe
appliance.
4
Check the connecting tube and joints for
leaks once again.
5
The water filter should be fixed at a
appropriate place where it is easy to reach
for replacement purposes.
EN