Cleaning The Click-On Attachments; Cleaning The Beard Styler Attachment - Philips S7000 Serie Mode D'emploi

- Each retaining ring has two recesses that fit
exactly in the projections of the shaving head
holder. Turn the ring clockwise until your hear 'click'
and the ring is fixed.
Note: Hold the shaving head holder in your hand
1 when you reinsert the shaving heads and reattach the
retaining rings. Do not place the shaving head holder
on a surface when you do this, as this may cause
damage.
8 Reattach the shaving head holder to the
bottom part of the shaving unit.

Cleaning the click-on attachments

Never dry the trimmer or beard styler
attachments with a towel or tissue, as this
may damage the trimming teeth.

Cleaning the beard styler attachment

Clean the beard styler attachment every time you
have used it.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the centre to pull it off the
attachment. Do not pull at the sides of the comb.
2 Switch on the appliance.
3 Rinse the beard styler attachment and the
comb separately under a hot tap for some
time.
4 After cleaning, switch off the appliance.
ENGLISH
25