Cleaning The Click-On Attachments - Philips S7000 Serie Mode D'emploi

30
English

Cleaning the click-on attachments

4 Press the on/off button on the SmartClean
system to start the cleaning program.
During the cleaning phase, the cleaning symbol
flashes. When the cleaning phase is done (after
approx. 10 minutes), the cleaning symbol lights
up continuously.
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches off automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged.
Charging takes approx. 1 hour.
5 To let the shaver dry, you can leave it in the
SmartClean system until your next shave. You
can also remove the shaver from the
SmartClean system, shake off excess fluid, open
the shaving unit and let the shaver air dry.
Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: If you disconnect the SmartClean system
from its power source, the cleaning program stops.
Never dry trimmer or beard styler attachments with
a towel or tissue, as this may damage the trimming
teeth.
The accessories supplied may vary for different
products. The box shows the accessories that have
been supplied with your product.