Philips S7000 Serie Mode D'emploi page 34

ENGLISH
34
Problem
The shaver is
not entirely clean
after I clean it in
the SmartClean
system.
Water is leaking
from the bottom
of the shaver.
The SmartClean
system does not
work when I
press the on/off
button.
Possible cause
You have not
placed the shaver in
the SmartClean
system properly, so
there is no electrical
connection between
the SmartClean
system and the
shaver.
The cleaning
cartridge is empty.
The replacement
symbol flashes to
indicate you have to
replace the cleaning
cartridge.
You have used
another cleaning
fluid than the original
Philips cleaning
cartridge.
During cleaning,
water may collect
between the inner
body and the outer
shell of the shaver.
The SmartClean
system is not
connected to the
mains.
Solution
Press down the top cap
('click') to ensure a proper
connection between the
shaver and the SmartClean
system.
Place a new cleaning
cartridge in the
SmartClean system (see
chapter 'Cleaning and
maintenance').
Only use the original
Philips cleaning cartridges.
This is normal and not
dangerous because all
electronics are enclosed in
a sealed power unit inside
the shaver.
Put the small plug in
SmartClean system and
put the adapter in the wall
socket.