BelFox Premium Slider 500 Mode D'emploi page 53

1 1 3 3 . . S S e e t t t t i i n n g g u u p p t t h h e e P P r r e e m m i i u u m m S S l l i i d d e e r r 5 5 0 0 0 0 / / 8 8 0 0 0 0 / / 8 8 0 0 0 0 i i
Place the Premium Slider on the intended surface. The drive gear should not
yet mesh with the gear rack. If necessary, lower the drive unit using the height
adjuster. (The motor and gear unit is height adjustable by approx. 175 mm.)
The emergency release must be set to "Unlocked".
Now align the operator exactly parallel to the door and fasten it to the founda-
tion or to the console in the Ground. (Through the slotted holes of the
mounting plate the drive can be readjusted a little bit).
Now the drive unit can be set to the desired height with the height adjustment.
1 1 4 4 . . I I n n s s t t a a l l l l a a t t i i o o n n o o f f t t h h e e d d r r i i v v e e
Fatal electric shock from mains voltage!
There is a risk of life-threatening / fatal electric shock on contact with the
mains voltage.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
x Electrical connections may only be carried out by a qualified electrician.
x When laying the power line, the applicable regulations must be observed
and complied with (IEC 364-4-41).
x Before carrying out any work, disconnect the system from the power
supply. Secure the system against unauthorized restarting of the system.
x Ensure that the on-site electrical installation complies with the relevant
protection regulations.
x To avoid hazards, a damaged mains connection cable must be replaced
by a qualified electrician with an undamaged mains connection cable.
x Use protective equipment during installation.
x
The power supply (usually 230 V) must match the rating plate.
DANGER
19