Intended Use; Non-Intended Use - BelFox Premium Slider 500 Mode D'emploi

These instructions must be handed over to the operator as an essential part of
the product. These instructions must be kept in a safe place and must be acces-
sible at all times to all users of the door system.

3.3. Intended use

This drive can be used in private and commercial applications.
The sliding gate operator may only be used with smooth-running gates, i.e. the
gate must open and close easily by hand.
The maximum permissible door weight and the maximum permissible door size
must not be exceeded.
Observe the manufacturer's specifications regarding the door system, consis-
ting of door and operator. You can avoid possible hazards in the sense of EN
13241-1 if the installation follows the instructions in this manual.
Doors that are operated with a drive must comply with the applicable stan-
dards.
The door must run smoothly so that the safety cut-out can react optimally.
The door must have a mechanical end stop in the open and closed position,
otherwise it can be pushed out of the guide when in the "emergency unlocked
state".
Door systems located in public areas and only equipped with a safety device,
e.g. force limiter, may only be operated under supervision.

3.4. Non-intended use

This operator is designed exclusively for opening and closing sliding gates.
This drive is not intended for continuous operation.
The operator must not be used on gates with inclines or declines.
The operator must not be used with heavy gates. Contact your door supplier
for heavy-going doors.
7