Astralpool JELLY - RGB Manuel D'installation Et D'entretien page 11

LuMIPLuS REMOTE CONTROL (Code 41988)
Operating frequency:
Reach in an open field:
Power:
Battery:
DESCRIPTION
The Remote Control features 8 LEDs that indicate the status on the top
and 4 push buttons on the bottom: COLOR, SEQuENCE, SPEED and
/ SLEEP.
These are the main functions of the remote control:
• Turn the projectors on/off.
• Select the colour: 12 fixed colours available.
• Select a sequence: 8 sequences available.
• Select the sequence speed: 8 speeds available for each sequence.
• Select a timed shut off: 8 sleep times available.
INSTALLATION
To be able to control the Jelly projector with the Remote Control, you must link it to the LumiPlus
Modulator:
Linking the Remote Control and the Modulator:
• Hold down the key (Off) on the Modulator, the green LED will flash quickly indicating that it
is in the Learning mode.
• Press any of the other keys on the remote: COLOR, SEQuENCE or SPEED. If you have
several Remote Controls, repeat the operation so that the Modulator responds to all of their
orders (maximum of eight).
unlinking the Remote Control and the Modulator:
• Hold down the key on the Modulator, the green LED will flash quickly indicating that it is in
the Learning mode.
• Press the key again.
N.B.: the Remote Control orders prevail over those from the Modulator.
OPERATION
Turning the projectors on
The projectors will turn on when you press any key. If you press the
on in the same state they were in before being turned off: fixed colour or a sequence of certain
colours and times.
If you press the COLOR key, the projectors turn on with the last fixed colour that was used.
If you press SEQuENCE or SPEED, they turn on with the last sequence used.
S I G N A T U R E
433 MHz
50 m.
10 mW
23AE 12 Vdc battery.
11
key, the projectors turn