Operation Of The Appliance; Switching The Appliance On And Off - Sharp KH-6I19FTPP-EU Guide D'utilisation

OPERATION OF THE
APPLIANCE
Use the induction cooking zones with
suitable cookware.
After the power supply is turned on, all
of displays light up for a moment. When
this time is over, the hob goes into stand-
by mode and is ready for operation.
The hob is controlled with electronic
sensors which are operated by touching
the related sensors. Each sensor
activation is followed by a sound signal
(buzzer).
Switching the appliance on:
Switch the hob on by pressing the ON/
OFF key All heater displays show a
static "0" and the bottom right dots blink.
(If no cooking-zone is selected within 20
seconds, the hob will automatically turn
off.)
Switching the appliance off:
Switch the hob off at any time by
pressing .
The ON/OFF key
priority in the switch off function.
Power management function
Thanks to the power management
function, the user can set the maximum
power of the hob if needed and power
limit is never exceeded.
How it works
If total power exceeds the adjusted
limit, the power management function
always has
EN - 8
decreases the last selected hob zone
power limit automatically, then the
display flashs and buzzer signal sounds.
The power level of other cooking zones
remain the same.
After energizing the hob, default power
limit occurs on the display for 4-5
seconds as shown figure A
Figure A
4 different power limits are available
(13A,15A,16A,32A)
Power Limit
13 A
15 A
16 A
32 A
Setting the power limit;
IMPORTANT:If higher power limit will
be adjusted than default power limit,
electrical network (cable, plug,fuse,
etc.) must be checked and changed
if needed by a qualified technician
according to local regulations.
After energizing the hob, in the first
60 seconds it is possible to set the
required power limit by following steps:
1. First you will see the default setting
on the display. (Figure A)
Required Cable
Size
min 3G1,5mm²
min 3G1,5mm²
min 3G1,5mm²
min 3G2,5mm²