Guarantee & Service - Philips GC8261 Mode D'emploi

Problem
The appliance does
not become hot.
Smoke comes out
of my new iron
when I switch it on.
The iron does not
produce any steam.
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
Guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Cause
There is a connection problem.
You have not switched on the appliance.
The set temperature is too low.
Some parts of the appliance have been
lightly greased in the factory and may
initially give off some smoke when heated.
There is not enough water in the water
tank.
The steam generator has not heated up
sufficiently.
The set ironing temperature is too low
for steam ironing.
GC8261/GC8260/GC8225/GC8220 only:
You have set steam setting a (no steam).
EnGlish
Solution
Check the mains cord, the plug and
the wall socket.
GC8261/GC8260/GC8225/GC8220:
Press the on/off button. GC8210: set
the on/off switch to 'on'.
Set a higher temperature.
This phenomenon is normal and
ceases after a short while.
Fill the water tank. See chapter
'Preparing for use', section 'Filling the
detachable water tank'.
Wait approx. 2 minutes. GC8261/
GC8260/GC8225/GC8220 only:
wait until the steam light stays on
continuously.
Set a temperature of 2 or higher.
Set steam setting ] (minimum
steam), [ (moderate steam) or p
(maximum steam).
15