General Instructions - WAGNER WOOD&METAL EXTRA Mode D'emploi

GB
Read the operating instructions carefully beforeusing the tool and observe the safety
instructions. Keep the operating instructions in a safe place. The safety instructions
for the basic unit apply to this Corner&Reach spray attachment.

General instructions

The Corner&Reach spray attachment was developed for applying water-soluble and low-
viscosity materials containing solvents.
The spray jet is deflected by 25° at the end of the 22 cm nozzle extension. This allows
problem-free coating of narrow spaces or points that are difficult to reach.
•
CAUTION! The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1 A, item 15) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
1) Gun body
3) Needle
5) Paint tube
7) Turning aid
9) Air cap
11) Trigger guard
13) Feed tube
15) Ventilating hose
17) Diaphragm
Assembly (Fig. 1-4)
Clip the needle onto the needle holders from above. (Fig. 2 A+ B)
Carefully attach the paint tube followed by the air tube (Fig. 3), and secure with the union nut.
Attach the air flap to the air tube. The position of the arrows must correspond. (Fig. 4 A+ B)
Align the feed tube (see instructions for the basic unit)
Spray on the container contents until there is very little remaining.
For spraying work with objects lying down, turn the feed tube forwards.
For spraying work on objects above head height, turn the feed tube to the rear.
Adjusting the spraying direction (Fig. 5 )
The rotary aid on the air tube always points in the same direction in which the spray jet is
deflected. To adjust the spraying direction, turn the air tube in the desired direction with
the union nut slightly undone. Then tighten the union nut again.
6
Corner&Reach spray attachment
Description (Fig. 1+6)
2) Needle holder
4) Nozzle seal
6) Air tube
8) Union nut
10) Material quantity regulation
12) Container seal
14) Container
16) Valve cover
18) Viscosity test cup