Replacement Of Batteries - Gree GEH09AA-K6DNA1E Instructions Originales

How to use the remote control to operate the unit
Combination of "+" and "-" buttons: About lock
17
Press " + " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is
locked, is displayed. In this case, pressing any button,
18 Combination of "MODE " and "-" buttons :
At unit OFF, press
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
19
Press " TEMP " and " CLOCK " simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays " SE " . Repeat the operation to quit the function.
20 Combination of " TEMP " and "CLOCK" buttons : About 8℃
Press " TEMP " and " CLOCK " simultaneously in HEAT mode to start
Nixie tube on the remote controller displays "
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
℉
21
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
★ Notes:
●
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
●
If the remote controller will not be used for a long time, please
remove batteries to prevent batteries from leaking.
●
The operation should be performed in its receiving range.
●
It should be kept 1m away from the TV set or stereo sound sets.
●
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
replace the batteries.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
About switch between Fahrenheit and centigrade
" "
" - "
MODE
and buttons simultaneously to switch between

Replacement of Batteries

blinks three times.
Heating Function
" and a selected temperature of " 8℃"
12
OPERATION INSTRUCTIONS
and .
℃ ℉
8℃ Heating Function
.
Sketch map for
replacing batteries