Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
TROUBLE SHOOTING
Overheated Back-up Batteries
The gate does not move when pressing
the button of the transmitter
The gate opens but does not close
The gate didn't achieve full open / close Update power current with the program
The photocells don't work
The remote control does not work
If any of the above trouble shooting procedure is not solving your problem, please
contact us with no hesitation
EN ::: 48
Check the wiring connection of the batteries.
1. Check if the voltage of the batteries is above 22V.
2. Make sure all the wiring connections are firmly
connected to the terminals on the PCB.
3. Make sure the fuse is workable on the panel
and power socket.
Check if the LED DL1 is flashing
Program H must be set up at H-0 and then,
check photocells connection and installation
7 (setting 7-1 to 7-6).
Update power current with the program
6 (setting 6-1 to 6-4).
Be carefull, if over-current will be update, and in
case of windy day, gate will stop without reason
during open/close
( but this is not a default)
Check that the photocells are activated with H
program: H-1
Check RX red light switch on, if so, reset
photocells installation (RX red light switch OFF)
Check batteries power, and that the antenna is
connected
Publicité
Chapitres
Table des Matières
