Setting; Transmitter Memorizing And Erasing Progress; System Learning, Reset Process And Led Display - SCS KIT AUTOMATISME Manuel D'installation Et D'utilisation

SETTING

A
TRANSMITTER MEMORIZING AND ERASING PROCESS
(1) Transmitter Memorizing: Press "RF Learn" button for 2 seconds, and the LED display
shows "CS"; then press any button of the transmitter; the LED display will blink twice and
then be off. The transmitter learning is done
LED2
LED display
LED1
ON
1
2 Sec
You can now use your remote control as follows :
ON
OFF
Remote controls reset: press and maintain «RF-Learn» during 5-6 seconds until the LED
display blinks twice and then is off.
B
SYSTEM LEARNING, RESET PROCESS, AND LED DISPLAY
CAUTION: Before proceeding to system learning, the transmitter memorizing process
has to be completed.
(1) To complete the system learning disengage the motor and remove it in the middle.
Then re-engage it.
Step1: Press "SET"; then press "SET" + "DOWN" for 3 seconds, and the LED display shows
1 2 3
"LE"
Step2: Press the top left button on time, the LED display should show "LP"
Step3: The gate goes to Auto-learning, please wait for the learning process to be
completed
6
2
full opening
lighty control
1 2 3
LED display
blink twice
pedestrian opening
LED display OFF
3
4 5
EN ::: 41
EN