SCS KIT AUTOMATISME Manuel D'installation Et D'utilisation page 44

EN
Over current
7
setting
Open Partially
8 (Pedestrian
mode)
9 Pre-flashing
Over current
A reverse
setting
Full open
remote switch
C
(on the remote
control)
EN ::: 44
7-1 2A
7-2 3A
7-3 4A
7-4 5A
7-5 6A
7-6 7A
8-1 3seconds
8-2 6seconds
8-3 9seconds
8-4 12seconds
8-5 15seconds
8-6 18seconds
The flashing light
blinks when the
9-0
gate starts to
move.
The flashing light
blinks 3 seconds
9-1
before the gate
starts to move.
A-0 Stop
A-1 Reverse 1 second
A-2 Reverse 3 second
Reverse to the
A-3
end
C-1 the top left
button
C-2 the top right
button
C-3 the bottom left
button
C-4 the bottom right
button
1. The function can adjust the
running force of motor to
be compatible with the gate
weight.
2. The factory setting is «7-5».
1. The function can adjust the
time of opening partially.
2. The factory setting is «8-2».
1. The factory setting is «9-1».
1. The factory setting is «A-3».
2. The reverse function only ope-
rates 3 times and then stops.
3. If gate reverses, the auto
close function will be cancelled.
1. The factory setting is «C-1».