Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PHOTOCELLS
The photocells are safety devices for control automatic gates. Consist of one transmit-
ter and one receiver based in waterproof covers; it is triggered while breaking the path
of the beams.
Detection Method
Sensing Range
Input Voltage
Contact Current
Response Time
Operation Indicator
Dimensions
Output Method
Current Consumption
Connection Method
Housing Material
Water Proof
Safety Standard
INSTALLATION SEE YOUR MODEL
STEP 1 : Open the cover.
STEPS 2 ET 3 : Mount the receiver and transmitter
on the proper position. Ensure there are no
obstacles between receiver and transmitter. For
optimal efficiency, the receiver and transmitter
should be properly aligned.
STEP 4 : Make the connections.
STEP 5 : Close the cover. Power-up the photocells
and make sure the LED light on receiver and
transmitter are ON.
Through Beam
MAX~10m
AC/DC 12~24V
TX: 30mA Max , RX: 25 mA Max
< 100ms
RX : Red LED On (beam broken) / Off
(beam aligned) TX : Red LED On
63 x 63 x 30 mm
Relay Output
Beam aligned : RX<25mA\TX<30mA
Beam broken : RX <10mA\TX <30mA
Terminal Block
ABS / PC
IP44
CE
EN
EN ::: 37
Publicité
Chapitres
Table des Matières
