Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
LED1
LED2
LED3
LED1
LED2
LED3
1
1
4
LED1
LED2
(2) To Reset Factory Setting:
4
LED3
Press UP and DOWN for 3 seconds, and the LED display shows "CL"
LED1
LED2
LED3
1
1
LED Display
EN ::: 42
Push
2
Push
2
Press
1~3 Sec
ON
OFF
Press
5
1~3 Sec
ON
OFF
5
Push
3 seconds
2
Push
3 seconds
2
"-L": The system learning is not done.
"OP": The system is in normal operation
To program, press SET button for 3 seconds, when the LED display change
from OP to 1, press UP or DOWN to change function settings (1 to P). Then
press SET to enter the sub function within each group, press UP or DOWN
to select sub functions and press SET for
"LE": Enter learning mode and then wait for learning instructions.
"LP": The system learning is in progress.
The Auto-learning process of gate moving:
"Gate open to the end- stop close to the end- stop."
"CL": Reset Factory Setting.
Press
3 Sec
Press
3 Sec
3
ON
OFF
ON
OFF
6
Programmable Functions
3
6
Publicité
Chapitres
Table des Matières
