Checking Or Changing The Set Parameters In The First Level; Parameter List - Dometic FRIGO EVAP404A Instructions De Montage

Frigo
➤ Use the buttons
➤ Press the SET button to confirm, the value stored flashes and after that next parameter is
displayed.
➤ Wait 15 seconds to leave the parameter level.
10.4 Checking or changing the set parameters in the first
level
I
NOTE
In the "Pr 2" level all available parameters are visible.
➤ To call up the second parameter level, press and hold the SET button and the
for at least 3 seconds. The LED "C" flashes. The description of the first parameter "LS" is
shown on the lower line in the display and the value set on the upper line.
➤ Select parameter "Pr 2" with the
➤ Briefly press the SET button and using the
with the SET button. "Pr 2" flashes in the display and then the first parameter "HY" is
shown.
➤ Use the or buttons to select all available parameters.
➤ Briefly press SET to change the value of each parameter.
➤ Use the buttons
➤ Press the SET button to confirm, the value stored flashes and after that next parameter is
displayed.
➤ Wait 15 seconds to leave the parameter level.
11

Parameter list

A
CAUTION!
z Deviations from the values stated in the lists can result in damage to the
load and the cooling system.
z When using for the first time, the parameters "Hr" and "tHr" must be pro-
grammed to the time interval for the first maintenance!
I
NOTE
(*) Values for 100 operating hours and first maintenance interval when using
the cooling system for the first time
28
or to enter a particular value.
button.
or to enter a particular value.
button enter the value "013", then confirm
Parameter list
button