Cleaning And Maintenance; Cleaning And Storage - Philips Multigroom QG33 Série Mode D'emploi

Body trimming (3-12mm)

Cleaning and maintenance

Cleaning and storage

- Take your time when you first start to trim
sensitive areas. You have to acquire practice
with the appliance. Your skin also needs some
time to adjust to the procedure.
- When you trim sensitive areas, we advise you
not to use the trimmer without the trimming
comb.
- When too many hairs have accumulated on the
appliance, blow out before use, for best
trimming results.
You can use the body comb attached to the full
size trimmer, to trim hairs below the neckline. You
can choose any setting between 3 and 12mm in
steps of 1 mm.
Switch off and clean the appliance after each use
(see 'Cleaning and maintenance').
Regular cleaning guarantees better grooming
results.
Never clean, remove or replace a shaving or
cutting unit while the appliance is switched on.
Always check if the water is too hot, to prevent
burning your hands.
Never dry cutting units or shaving foils with a
towel or tissue, as this may cause damage.
Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol or
acetone to clean the appliance.
17
English