Replacing The Lamp; Closing The Door - Electrolux ERGP3314AW Mode D'emploi

Problem
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature dis-
play.
dEMoappears on
the Display.

6.1 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .

6.2 Closing the door

1. Clean the door gaskets.
Possible cause
Shopping function switch-
ed on.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
2.
3.
Solution
Switch off Shopping man-
ually, or wait to set the tem-
perature until the function
has reset automatically. Re-
fer to "Shopping function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the OK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 37