Adventys GL 650 FL Guide D'utilisation page 19

Mechtnictli inattlilittion:
1 ) Realize a cut out of : 346x346 mm
2) Put the frame on the cut
3) Insert the kit inside the cut and adjust the 4 screws in order to obtain the top of the furniture and the
top of the vitroceramic glass at the same level.
4) Remove the kit and deposit the thermal high-strength glue on the 4 supports.
5) Insert second time the kit inside the cut with better centering.
6) Press the kit until to touch the 4 screws.
7) Clean the surplus of glue to have no overflowing above the upper plan.
8) Leave the glue to get dry without warming the integrated kit.
9) Make the seal ( food quality).
10) Leave the seal to get dry without warming the integrated kit.
19