Hitachi SAT-180 Mode D'emploi page 7

d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper.
Larger sanding paper extending beyond the sanding
pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.
SAFETY WARNINGS SPECIFIC FOR
POLISHING OPERATIONS
a) Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle
your fingers or snag on the workpiece.
SPECIFICATIONS
Voltage (by areas)*
Power input
No load speed
Sanding Disc Size outer dia. × inner dia.
Weight (without cord, standard accessories)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) 180mm Sanding Disc ............................................... 5
(Grain: c-p24, c-p30, c-p50, c-p80, c-p120 . 1 each)
(2) Rubber Pad ................................................................ 1
(3) 180mm Wool Bonnet ............................................... 1
(4) Wrench (A) ................................................................ 1
(5) Wrench (B) ................................................................. 1
(6) Side Handle ............................................................... 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Grinding metal surfaces
Preliminary sanding of metal surfaces before
painting, rust removal, removing old paint before
repainting.
Finishing woodwork, correcting projections of timber
from joints or assemblies.
Preliminary sanding of wood surfaces before
applying paint.
PRECAUTIONS ON USING SANDER
POLISHER
1. Never mount a grinding wheel and attempt to use
this tool as a disc grinder.
2. Always hold the body handle and side handle of
the power tool firmly.
Otherwise the counterforce produced may result in
inaccurate and even dangerous operation.
3. Ensure that sparks resulting from use do not create
a hazard e. g. do not hit persons, or ignite flammable
substances.
4. Always use protective safety glasses and hearing
protectors, use other personal protective equipment
such as gloves, apron and helmet when necessary.
5. Always use eye and ear protection.
Other personal protective equipment such as dust
mask, gloves, helmet and apron should be worn
when necessary.
If in doubt, wear the protective equipment.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
750 W*
3400/1900min
180 × 22 mm
2.9 kg
Polishing or shining painted metal surfaces, such
as those of automobiles, trains, elevators,
refrigerators, sewing machines, washing machines,
metal appliances, etc.
Polishing varnished surfaces of wooden furniture,
etc.
Shining synthetic resin or ebonite products.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
English
-1
6